Paper validation using Ansys – Heat exchanger nanofluid

“Experimental analysis for heat transfer of nanofluid with wire coil
turbulators in a concentric tube heat exchanger.”

You have to validate the results of the above experiment using Ansys, that is to perform a numerical analysis by creating an accurate cfd model.

Also, screen record the procedure. I have attached the research paper below and also attached a word document specifying in brief what the research paper is about.

Details of research paper in brief :-

• Heat exchanger –

Concentric heat exchanger [with and without wire coil turbulators of pitches 25 and 39 mm]

• Fluid – 1. pure water

1. 0.4% Al2O3 water nanofluid
2. 0.8% Al2O3 water nanofluid
3. 1.2% Al2O3 water nanofluid
4. 1.6% Al2O3 water nanofluid

• Calculation :- For Reynolds number – 4000, 8000, 12000, 16000, 20000
  1. Nusselt number vs Reynolds number
  2. Total heat coefficient vs Reynolds number
  3. Friction factor vs Reynolds number

This is to be done for :-

1. Concentric heat exchanger without wire coil – Pure Water
2. Concentric heat exchanger with 25 mm wire coil – Pure water
3. Concentric heat exchanger with 39 mm wire coil – Pure Water

Also in place of pure water, repeat the above for 0.4%, 0.8%, 1.2%, 1.6% Al2O3 water nanofluid.